Subject	I've used mine about 5-7 times now and still good as new.
Posted by	PiotrC70 on February 21, 2013 at 8:38 PM
	This message has been viewed 139 times.
In Reply To	Those are the same pads I'm using, got them in a kit posted by Jayru on February 21, 2013 at 06:44 PM
Message	I fill up about 2-3 gallons of REALLY warm water and right after I'm done using the pad, I spray the hell out of it with simple green. After letting it sit for ~1min, I dunk it in the water, folding the pad only in 1/2 and squeeze to get the crud out... I've I've compressed the pad completely as if you're wringing out a towel minus the twisting. I dry the pads out pad side down on a towel to allow them to drain and so the moisture doesn't create mold. The ONLY problem some of the pads have experienced is a slight cupping on the velcro side but doesn't affect performance in any way once you stick it to the buffer. 1993 TT. R.I.P. 09.15.2010
Follow Ups	Detailed the Z last weekend - was a huge improvement! - Jayru 16:53:49 02/21/13 Well done! (n/m) - samsung-Z [Houston] 17:58:53 02/21/13 Nice work. - SWhiteTT(GA) 18:08:08 02/21/13 Some tips I've read: - PiotrC70 18:10:31 02/21/13 Those are the same pads I'm using, got them in a kit - Jayru 18:44:21 02/21/13 I've used mine about 5-7 times now and still good as new. - PiotrC70 20:38:59 02/21/13 Nice. I'll try the Simple Green method - Jayru 20:41:16 02/21/13 Nice! (n/m) - Spongerider :) 18:18:53 02/21/13 Much better.. - KongZTT GT28RS MD 18:21:20 02/21/13 Yea, there were definitely still some imperfections there - Jayru 18:47:47 02/21/13 What were the steps you went through? - KongZTT GT28RS MD 19:31:03 02/21/13 Shit, I did claybar, I forgot to mention that in the post! - Jayru 19:36:44 02/21/13 Haha you'll do fine man.. - KongZTT GT28RS MD 19:43:21 02/21/13 BTW, your car came out great too. (n/m) - Jayru 19:55:05 02/21/13 Was that your first time wetsanding in those pictures? Nice! - ZinnZ32 00:48:24 02/22/13 You don't really want any pressure - Jayru 12:38:46 02/22/13 excellent job...looks much better (n/m) - RobZ32 22:25:28 02/21/13 Looks great! (n/m) - Burton(PA/FL) 22:51:43 02/21/13 dude... I didn't even see that link you posted .. - KongZTT GT28RS MD 23:23:49 02/21/13 was fixing the bent fender pinch weld difficult? - jzx 03:13:29 02/22/13 Not really difficult. Just took a little time. - Jayru 12:35:15 02/22/13
Post a Followup	You cannot reply to this message because you are not logged in.