Subject	Cp Pistons 87.5mm
Posted by	ZxMoslowxZ on February 21, 2013 at 10:13 AM
	This message has been viewed 173 times.
Message	I was wondering if the machine shop just did a .020 bore over id be good or is thier more to it? Just wana make sure its done right
Follow Ups	Cp Pistons 87.5mm - ZxMoslowxZ 10:13:21 02/21/13 The machine shop will need the pistons and the block. - michaell32 (FL) 10:20:10 02/21/13 Ok sweet. - ZxMoslowxZ 10:42:52 02/21/13 Would you use an OEM head gasket with a .020 bore? - Sjpco07 01:07:53 02/22/13 Yes. OEM can accommodate 88 mm, maybe larger (n/m) - ZXoltan 07:11:42 02/22/13 I am just going to do cometic head gaskets (n/m) - ZxMoslowxZ 12:49:53 02/23/13 I would recommend OEM over cometic. - michaell32 (FL) 13:49:54 02/23/13
Post a Followup	You cannot reply to this message because you are not logged in.