TwinTurbo.NET: Nissan 300ZX forum - I know exactly what you're talking about but I don't know
People Seeking Info
 
   


     
Subject I know exactly what you're talking about but I don't know
     
Posted by Zvil (FL) on February 18, 2013 at 9:01 AM
  This message has been viewed 143 times.
     
In Reply To Re: Cold hesitation problem FIXED posted by backinblack626 on February 18, 2013 at 07:51 AM
     
Message What year the motor is.... I looked at the spline in the cam, it didn't look worn out.... the CAS splines did though so I'm going to check what the head casting is, if it says 10Y I'm screwed and I'll have to get the repair kit but I would rather sell the motor and get a jdm TT. I noticed I reference marked the CAS with a sharpie to know where the timing was set and the mark is missing on the cas itself so I'm thinking I may have pulled the CAS of this motor to sell to someone then I un-luckily replaced it with a bad CAS since I do have that bad head lying around in my garage.

*disclaimer*: all that I say may be true or I may be completely wrong and I accept that.... please, it is your duty as another person on the internet to in-politely tell me how wrong I am :)

"The dreaded 2nd windshiled wiper swipe when you turn it off its almost like tis showing you that it's boss, and it doesn't have to stop when you tell it to :("-College Boy

(discussion on ptu relocation)
"No good reason to put it there anyway. -Bernie (NoVA)
False -vorpalZ
False. -Bernie (NoVA)
You're correct, there are 3 good reasons -vorpalZ
False. -Bernie (NoVA)
Wow, right again, just remembered another, make that 4 -vorpalZ"
XD

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.