Subject	I tried sealant and not threading it all the way
Posted by	NextZ on February 11, 2013 at 6:56 PM
	This message has been viewed 129 times.
In Reply To	Do you have to bottom out the threads for it to seal posted by ZXoltan on February 11, 2013 at 04:52 PM
Message	but it leaks. 64752/>
Follow Ups	Fitting to relocate oil pressure sensor - NextZ 11:51:03 02/11/13 Mine wasnt too close, have a pic? (n/m) - Z32TT-R 12:04:18 02/11/13 Its standard 1/8" BSPT size, look on mcmaster for fittings. - Lowfategg 12:15:18 02/11/13 Here's a pic of the brass fitting - NextZ 13:19:09 02/11/13 plumbing section of lowes has the same brass fittings - youngbloodz 15:42:36 02/11/13 Thanks. I was thinking of cutting the fitting threads - NextZ 15:57:42 02/11/13 Do you have to bottom out the threads for it to seal - ZXoltan 16:52:49 02/11/13 I tried sealant and not threading it all the way - NextZ 18:56:22 02/11/13 i used pipe sealant tape and havent had any leaks. I also - youngbloodz 00:02:03 02/12/13 Thanks. I was thinking of cutting the fitting threads - NextZ 18:54:56 02/11/13 RHD Z's have the sensor on the left side turbos oil feed. - LivinTheDream 20:25:16 02/11/13 Re: RHD Z's have the sensor on the left side turbos oil feed. - rmalik23 01:03:53 02/12/13 Re: RHD Z's have the sensor on the left side turbos oil feed. - rmalik23 01:23:15 02/12/13 I'll have to check to see if the wire will reach (n/m) - NextZ 16:57:45 02/12/13
Post a Followup	You cannot reply to this message because you are not logged in.