Subject	Its standard 1/8" BSPT size, look on mcmaster for fittings.
Posted by	Lowfategg on February 11, 2013 at 12:15 PM
	This message has been viewed 311 times.
In Reply To	Fitting to relocate oil pressure sensor posted by NextZ on February 11, 2013 at 11:51 AM
Message	1/8" NPT can work, but you will need to tap the oil tree larger and the sensor fitting is a bit loose though. I used NPT 1/8" since I have a T in the feed to an aftermarket pressure sensor (so I can have the stock one as well).
Follow Ups	Fitting to relocate oil pressure sensor - NextZ 11:51:03 02/11/13 Mine wasnt too close, have a pic? (n/m) - Z32TT-R 12:04:18 02/11/13 Its standard 1/8" BSPT size, look on mcmaster for fittings. - Lowfategg 12:15:18 02/11/13 Here's a pic of the brass fitting - NextZ 13:19:09 02/11/13 plumbing section of lowes has the same brass fittings - youngbloodz 15:42:36 02/11/13 Thanks. I was thinking of cutting the fitting threads - NextZ 15:57:42 02/11/13 Do you have to bottom out the threads for it to seal - ZXoltan 16:52:49 02/11/13 I tried sealant and not threading it all the way - NextZ 18:56:22 02/11/13 i used pipe sealant tape and havent had any leaks. I also - youngbloodz 00:02:03 02/12/13 Thanks. I was thinking of cutting the fitting threads - NextZ 18:54:56 02/11/13 RHD Z's have the sensor on the left side turbos oil feed. - LivinTheDream 20:25:16 02/11/13 Re: RHD Z's have the sensor on the left side turbos oil feed. - rmalik23 01:03:53 02/12/13 Re: RHD Z's have the sensor on the left side turbos oil feed. - rmalik23 01:23:15 02/12/13 I'll have to check to see if the wire will reach (n/m) - NextZ 16:57:45 02/12/13
Post a Followup	You cannot reply to this message because you are not logged in.