Subject	I worked in a shop where we had one that was mobile
Posted by	BlackholeZ on February 07, 2013 at 3:05 AM
	This message has been viewed 290 times.
In Reply To	I-beam hoist posted by bartz32tt on February 06, 2013 at 11:12 AM
Message	2 12 ft tall A-frames on each end with a 12 ft I--beam between. Four heavy duty casters and a chain winch. We used it to move machine tools, pull engines out of cars, cars off of engine/subframe assemblies. Super handy. -Dan BlackholeZ VTC Solenoid Caps Installation Procedure "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines "You're the Skrillex of Z32s." BradX (UF)
Follow Ups	NZR: Large garage recommedations. - DWoods 22:16:23 02/05/13 I've always though about a "bi" level shop. - 1badz32 (MN) 22:32:16 02/05/13 Re: I've always though about a "bi" level shop. - DWoods 22:35:14 02/05/13 Check zoning etc - many places will not allow work pits (n/m) - Bernie (NoVA) 22:50:43 02/05/13 Re: Check zoning etc - many places will not allow work pits - DWoods 23:14:44 02/05/13 I guess one would have to check the deffinition of "pit" - 1badz32 (MN) 23:44:56 02/05/13 Re: I guess one would have to check the deffinition of "pit" - DWoods 23:52:37 02/05/13 Just get a 2 post lift. (n/m) - Evan(CA) 00:07:15 02/06/13 2nd, or a 4-post - bartz32tt 11:01:58 02/06/13 2 post vs. 4 post lifts - Zorpman 10:49:16 02/08/13 So much for "land of the free"! (n/m) - spicyZ 14:46:29 02/06/13 OWB? ICF? WTF? I need translations. - BigTDogg (MA) 10:13:21 02/06/13 Re: OWB? ICF? WTF? I need translations. - DWoods 13:04:44 02/06/13 I-beam hoist - bartz32tt 11:12:07 02/06/13 Re: I-beam hoist - DWoods 13:07:00 02/06/13 Re: I-beam hoist - DWoods 23:09:12 02/06/13 I worked in a shop where we had one that was mobile - BlackholeZ 03:05:45 02/07/13 You can get an A Frame hoist from Harbor Freight - Zorpman 10:31:16 02/08/13 www.garagejournal.com - lidz 14:53:36 02/06/13 Definitely a lift in the tall section - Technomancer 14:36:26 02/07/13 Re: Definitely a lift in the tall section - DWoods 18:14:06 02/07/13 Just got done with 4000sqft garage-some thoughts-Long - Zorpman 17:06:21 02/07/13 Wow! - DWoods 18:11:24 02/07/13 That is a very thoughtful and comprehensive list. THX. (n/m) - Gordo 93TT Daytona 20:26:53 02/07/13
Post a Followup	You cannot reply to this message because you are not logged in.