Subject	You might have to take it apart.
Posted by	AHos(Chicago) on February 05, 2013 at 3:53 PM
	This message has been viewed 121 times.
In Reply To	Starter solenoid disassembly posted by Rob260 on February 05, 2013 at 03:00 AM
Message	A picture would help, but there should be a cap over the plunger. Remove the cap and you should be able to access the stud from the inside. I think it's just pressed in.
Follow Ups	Starter solenoid disassembly - Rob260 03:00:13 02/05/13 Vice grips? (n/m) - Summeronthechain (MN) 08:00:01 02/05/13 Re: Vice grips? - Rob260 14:15:31 02/05/13 Re: Vice grips? - Rob260 16:10:20 02/05/13 You can delete your duplicate post if nobody has responded. (n/m) - johnnysombrero 08:31:14 02/05/13 You might have to take it apart. - AHos(Chicago) 15:53:43 02/05/13 Re: You might have to take it apart. - Rob260 16:12:23 02/05/13 Re: You might have to take it apart. - Rob260 16:39:05 02/05/13 I think there's an echo...echo in here :-O (n/m) - ZXoltan 20:36:02 02/05/13 Re: I think there's an echo...echo in here :-O - Rob260 05:26:42 02/06/13 Re: I think there's an echo...echo in here :-O - Rob260 13:10:56 02/06/13
Post a Followup	You cannot reply to this message because you are not logged in.