TwinTurbo.NET: Nissan 300ZX forum - I use the Z1 10mm spacer kit to clear my Z1 13" bbk with
People Seeking Info
 
   


     
Subject I use the Z1 10mm spacer kit to clear my Z1 13" bbk with
     
Posted by *BK300ZX* on February 04, 2013 at 12:50 PM
  This message has been viewed 168 times.
     
In Reply To What size/offset? I didn't see it in your profile... (n/m) posted by evan_aggie on February 02, 2013 at 09:24 PM
     
Message my current rpf1's 18x9.5 +38 up front with a 265/35/18 tire. It is the bare minimum for clearance. I used to have a pair in the 17x9 +35 size and they would clear a little easier with the same 10mm spacer for my setup. I believe the r33 front rotors are a true 13inches too. So you should be able to clear your setup with a 10mm spacer. As for tire choice, that 255/40/17 should fit just fine with a decent ride height. I'm fitting my current setup with very minimal (if any) rubbing at the very extremes and my front fender height is at 13.5" from the ground with the negative camber settings at the oem limit. I am probably going to drop my ride height some more with minimal side effects.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.