Subject	you have air in your system
Posted by	aliaZ on February 03, 2013 at 3:53 PM
	This message has been viewed 201 times.
In Reply To	vent thread posted by ZXER on February 03, 2013 at 03:26 PM
Message	Bleeding is so much easier if you delete the bleed point at the fender by either joining the two hard lines from the master and slave with a union or just running some flex line straight from the master to the slave. I know you said you weren't looking for any solutions, but too bad
Follow Ups	vent thread - ZXER 15:26:59 02/03/13 if you've heard it all then it should be fixed by now - white22sky 15:39:22 02/03/13 you have air in your system - aliaZ 15:53:12 02/03/13 He's already been told this, even though its correct - white22sky 16:12:36 02/03/13 Why did Nissan put this bleed point there anyway? - ZXoltan 17:24:05 02/03/13 I chalk it up to over engineering. I deleted mine , i just - white22sky 17:58:35 02/03/13 It is a pulsation dampener - aliaZ 22:16:06 02/03/13 Like the good reason they had for having TB coolant lines? (n/m) - PiotrC70 22:21:43 02/03/13 LOL... you sold me ;-) - ZXoltan 07:10:04 02/04/13 I ended up removing mine completely and ran the SZ - PiotrC70 08:03:30 02/04/13 delete the upper clutch bleed point - LJZTT 16:29:46 02/03/13 Yep, even with only 2 bleed points it still takes a lot of - JonnyZ(SoCal) 17:12:26 02/03/13 Check the vacuum booster before you do anything else... - RonZ300 (Socal) 16:59:08 02/03/13 Take a break. - njz 17:07:42 02/03/13 How many clutches have you installed and on average how long - TTZ2NV(EPTmotorsports) 00:50:34 02/04/13
Post a Followup	You cannot reply to this message because you are not logged in.