Subject	sure but this writeup was for the Stanza 60mm TB
Posted by	fst300zx on January 31, 2013 at 1:16 AM
	This message has been viewed 115 times.
In Reply To	I think it would be better to have the ports match posted by michaell32 (FL) on January 30, 2013 at 09:49 PM
Message	He could be going with the 58mm Z1 which will match up. And if he is going bigger have Rob port them to 62. Just my two cents ">
Follow Ups	Port manifold but run with stock TB's for time being? - Jkova300z 20:51:03 01/30/13 Without having the tbs in hand, I wouldnt. - michaell32 (FL) 21:03:13 01/30/13 Actually the plenum opening can be larger than the TB - ZXoltan 21:29:03 01/30/13 Sure. buy 58mm gaskets, center them, trace, grind, done. (n/m) - Red Hawk (CO) 21:48:29 01/30/13 I think it would be better to have the ports match - michaell32 (FL) 21:49:40 01/30/13 sure but this writeup was for the Stanza 60mm TB - fst300zx 01:16:54 01/31/13 depends - aliaZ 22:25:57 01/30/13 also, if you get z1 58 you can have rob port them to 61mm (n/m) - toykoz32 01:58:53 01/31/13 You can center the stanza/240sx tb's by enlarging the - Evan_Wright (Ca) 10:45:03 01/31/13 I suppose you could oval the holes - aliaZ 11:54:12 01/31/13
Post a Followup	You cannot reply to this message because you are not logged in.