Subject	Drilled for EGT
Posted by	VeganCannibal on January 30, 2013 at 12:13 PM
	This message has been viewed 159 times.
In Reply To	MSP Manifolds.. posted by inf on January 30, 2013 at 11:26 AM
Message	I drilled and tapped my MSManis for an EGT sensor. Stock location for EGR near #6. There is a raised nub that will work fine for EGR also. Emission concerns? If not, no need for EGR.
Follow Ups	MSP Manifolds.. - inf 11:26:23 01/30/13 I think you should be able to drill. - SimaYi 11:45:01 01/30/13 Run the stock manifold (n/m) - thumper (Los Angeles) 11:47:25 01/30/13 LOL! You take care of that business with Coz, Jim? (n/m) - ForceFedTT (SoCal) 20:02:36 01/30/13 Drilled for EGT - VeganCannibal 12:13:32 01/30/13 Ya, California..heh.. - inf 12:18:13 01/30/13 Mike left a flat spot so they could be drilled/tapped - ZXoltan 12:28:36 01/30/13 EGR or EGT? (n/m) - Woody75 (Denver) 12:26:36 01/30/13 egr (n/m) - inf 12:27:21 01/30/13 You can get them with the EGR fitting. - Woody75 (Denver) 13:15:45 01/30/13 I've had Mike pre-drill and tap for EGR before shipping (n/m) - RevTech 13:23:46 01/30/13 Yep. When you order the manis, request that they be - ForceFedTT (SoCal) 20:01:15 01/30/13
Post a Followup	You cannot reply to this message because you are not logged in.