Subject	No problem, I think the scotch tape method might be
Posted by	Zblackbeast on January 18, 2013 at 6:26 AM
	This message has been viewed 72 times.
In Reply To	that's very creative, thank you !! (n/m) posted by surfer31337 on January 16, 2013 at 09:36 PM
Message	better, but I would pre poke holes in the ends.
Follow Ups	request some advice for Z1 shifter install - surfer31337 23:37:43 01/15/13 Re: request some advice for Z1 shifter install - nissan300zxtt215 23:44:10 01/15/13 Re: Re: request some advice for Z1 shifter install - surfer31337 23:51:00 01/15/13 The "abyss" is right under your car. - TriniTT 23:59:55 01/15/13 isnt is actually the tranny heat shield? (n/m) - Atl300zxTT 09:41:21 01/16/13 ok, maybe it's not quite the abyss !! (n/m) - surfer31337 21:38:53 01/16/13 Dab some grease on the thin washers, works great to hold em (n/m) - ttsmokin 00:03:20 01/16/13 ^^^^ this is your answer (n/m) - DSM_EX-DRIVER 00:38:26 01/16/13 Re: Dab some grease on the thin washers, works great to hold em - surfer31337 21:35:22 01/16/13 I installed the Z1 shifter 2 weeks ago. The instructions - Zblackbeast 06:42:41 01/16/13 that's very creative, thank you !! (n/m) - surfer31337 21:36:42 01/16/13 No problem, I think the scotch tape method might be - Zblackbeast 06:26:17 01/18/13 Scotch tape all the way around once - Joe@ZSpeedperformance 15:33:25 01/16/13 thanks !! i will keep this in mind for next time (n/m) - surfer31337 21:37:19 01/16/13
Post a Followup	You cannot reply to this message because you are not logged in.