Subject	Scotch tape all the way around once
Posted by	Joe@ZSpeedperformance on January 16, 2013 at 3:33 PM
	This message has been viewed 154 times.
In Reply To	request some advice for Z1 shifter install posted by surfer31337 on January 15, 2013 at 11:37 PM
Message	Holds the washers in place and then you can pop through the tape with the bolt, No need to remove, it will not cause any issues.
Follow Ups	request some advice for Z1 shifter install - surfer31337 23:37:43 01/15/13 Re: request some advice for Z1 shifter install - nissan300zxtt215 23:44:10 01/15/13 Re: Re: request some advice for Z1 shifter install - surfer31337 23:51:00 01/15/13 The "abyss" is right under your car. - TriniTT 23:59:55 01/15/13 isnt is actually the tranny heat shield? (n/m) - Atl300zxTT 09:41:21 01/16/13 ok, maybe it's not quite the abyss !! (n/m) - surfer31337 21:38:53 01/16/13 Dab some grease on the thin washers, works great to hold em (n/m) - ttsmokin 00:03:20 01/16/13 ^^^^ this is your answer (n/m) - DSM_EX-DRIVER 00:38:26 01/16/13 Re: Dab some grease on the thin washers, works great to hold em - surfer31337 21:35:22 01/16/13 I installed the Z1 shifter 2 weeks ago. The instructions - Zblackbeast 06:42:41 01/16/13 that's very creative, thank you !! (n/m) - surfer31337 21:36:42 01/16/13 No problem, I think the scotch tape method might be - Zblackbeast 06:26:17 01/18/13 Scotch tape all the way around once - Joe@ZSpeedperformance 15:33:25 01/16/13 thanks !! i will keep this in mind for next time (n/m) - surfer31337 21:37:19 01/16/13
Post a Followup	You cannot reply to this message because you are not logged in.