Subject	request some advice for Z1 shifter install
Posted by	surfer31337 on January 15, 2013 at 11:37 PM
	This message has been viewed 227 times.
Message	Hi everyone, I got my solid shift mount installed, torqued down but then I ran out of daylight and it got too cold to continue working. This does give me the chance to regroup and ask about the shifter install. do you know any tips for installing the Z1 shifter? in particular, it has these thin washers (instead of bushings which were easier to hold in place) and i don't want to drop the washers into the abyss - can you suggest a method or "trick" to hold the washers onto the shifter while i line up the bolt? one other question, should i put any grease on the bolt which attaches the shifter to the linkage? Thanks ! :-)
Follow Ups	request some advice for Z1 shifter install - surfer31337 23:37:43 01/15/13 Re: request some advice for Z1 shifter install - nissan300zxtt215 23:44:10 01/15/13 Re: Re: request some advice for Z1 shifter install - surfer31337 23:51:00 01/15/13 The "abyss" is right under your car. - TriniTT 23:59:55 01/15/13 isnt is actually the tranny heat shield? (n/m) - Atl300zxTT 09:41:21 01/16/13 ok, maybe it's not quite the abyss !! (n/m) - surfer31337 21:38:53 01/16/13 Dab some grease on the thin washers, works great to hold em (n/m) - ttsmokin 00:03:20 01/16/13 ^^^^ this is your answer (n/m) - DSM_EX-DRIVER 00:38:26 01/16/13 Re: Dab some grease on the thin washers, works great to hold em - surfer31337 21:35:22 01/16/13 I installed the Z1 shifter 2 weeks ago. The instructions - Zblackbeast 06:42:41 01/16/13 that's very creative, thank you !! (n/m) - surfer31337 21:36:42 01/16/13 No problem, I think the scotch tape method might be - Zblackbeast 06:26:17 01/18/13 Scotch tape all the way around once - Joe@ZSpeedperformance 15:33:25 01/16/13 thanks !! i will keep this in mind for next time (n/m) - surfer31337 21:37:19 01/16/13
Post a Followup	You cannot reply to this message because you are not logged in.