| Message |
Data is gathered at the rear wheels, that is as accurate as it gets for each dyno. There are ways to estimate the drivetrain losses, but this estimation degrades the accuracy of the measurement that the dyno made. If you are comparing your dyno run to a new car that the factory says makes X hp, a flywheel number will be useful. If you are talking tuner with the car guys, whp is pretty standard.
-Dan BlackholeZ VTC Solenoid Caps Installation Procedure "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines "You're the Skrillex of Z32s." BradX (UF) |
 |