Subject	Anyone go back to the stock pullies?
Posted by	BlackholeZ on January 07, 2013 at 10:46 PM
	This message has been viewed 152 times.
Message	After driving a bone stock Z again I kinda like the drivability of having more rotating inertia. Also Driving an S2000 recently I kinda liked the kick in the pants from quick shifts while the engine is still spun up. Anyone put the heavy stuff back on? Notice a difference? -Dan BlackholeZ VTC Solenoid Caps Installation Procedure "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines "You're the Skrillex of Z32s." BradX (UF)
Follow Ups	Anyone go back to the stock pullies? - BlackholeZ 22:46:34 01/07/13 i have an ati damper to install, i'll see if i notice (n/m) - BoneZ (MD) 07:27:19 01/08/13 ATI dampners are top notch, I've installed these on a few - TTZ2NV(EPTmotorsports) 10:04:28 01/08/13 don't know if you're joking but when I drag raced my Z - Zvil (FL) 11:40:47 01/08/13 come to think of it I have done that - BlackholeZ 17:25:39 01/08/13 Re: Anyone go back to the stock pullies? - Rob260 17:14:51 01/08/13 what kind of clutch do you have? - BlackholeZ 17:24:17 01/08/13
Post a Followup	You cannot reply to this message because you are not logged in.