Subject	Re: What info did you use?
Posted by	DSM_EX-DRIVER on December 21, 2012 at 8:23 PM
	This message has been viewed 177 times.
In Reply To	What info did you use? posted by BlitZ91TT on December 21, 2012 at 05:53 PM
Message	Its not hard i didnt use any directions, its basically just removing (hicas lines, solenoid, pump, res) and replacing. The na pump bracket to block will need different length bolts if you dont have them (i went to ace hardware) and also a 3 rib belt. The hardest part is removing the rear rack. I didnt have a ball joint separator so i just unbolted the rack and unscrewed the inner ends from the outer ones (marked with crayon) and put the rack in a vise and transfered the inner ends to the eliminator bar and installed it back into the outer ends. Obviously doing it this way needs aligning right away.
Follow Ups	How long does a complete HICAS Removal take? - BlitZ91TT 12:40:09 12/21/12 Re: How long does a complete HICAS Removal take? - DSM_EX-DRIVER 16:16:30 12/21/12 What info did you use? - BlitZ91TT 17:53:02 12/21/12 Well If you get the SPL kit it has everything you need and - LivinTheDream 19:42:14 12/21/12 Re: What info did you use? - DSM_EX-DRIVER 20:23:01 12/21/12 doing it right and clean...maybe 8 hours total. - genic 23:41:21 12/21/12 Why would it matter if they did the bar, or not? - AHos(Chicago) 01:51:56 12/22/12 you answered your own question. (n/m) - genic 14:19:08 12/23/12 "what a shame SPL doesnt do the hicas removal bar" - AHos(Chicago) 17:43:13 12/23/12 I am with these guys about 7 hours to remove all the - John (MD) 11:11:12 12/25/12
Post a Followup	You cannot reply to this message because you are not logged in.