Subject	Re: OK...and what about the coatings? Any info on how they hold
Posted by	94ttz32 on December 18, 2012 at 8:58 AM
	This message has been viewed 102 times.
In Reply To	OK...and what about the coatings? Any info on how they hold posted by ZXoltan on December 18, 2012 at 08:38 AM
Message	Yes I've seen where they do hold up better than no coated bearings http://a5.sphotos.ak.fbcdn.net/hphotos-ak-ash4/460260_456597067700142_1938695651_o.jpg
Follow Ups	A and half year review on my built Engine from EP RACING - 94ttz32 21:02:35 12/17/12 I didn't read anything you wrote, I just wanted to comment - inf 21:17:47 12/17/12 Re: I didn't read anything you wrote, I just wanted to comment - 94ttz32 21:23:58 12/17/12 How many miles did you put the engine since the build? - BlitZ91TT 21:22:43 12/17/12 Re: How many miles did you put the engine since the build? - 94ttz32 21:28:02 12/17/12 Thanks! Mitch and I go way back. Good to know - BlitZ91TT 08:25:49 12/18/12 Glad to hear more and more good posts about EP Racing.. - KongZTT GT28RS MD 23:08:17 12/17/12 is this a positive or negative review? (n/m) - ZiNnYc 06:40:03 12/18/12 Re: is this a positive or negative review? - 94ttz32 06:56:41 12/18/12 Re: Re: is this a positive or negative review? - 94ttz32 07:06:47 12/18/12 What is a smother of 5 ? (n/m) - jlag 07:42:01 12/18/12 A mathematical factor in the dyno software used - boileralum 07:58:18 12/18/12 Thanks (n/m) - jlag 08:01:05 12/18/12 Did you get coated bearings from Mitch? - ZXoltan 07:49:59 12/18/12 Re: Did you get coated bearings from Mitch? - 94ttz32 08:27:52 12/18/12 OK...and what about the coatings? Any info on how they hold - ZXoltan 08:38:30 12/18/12 Re: OK...and what about the coatings? Any info on how they hold - 94ttz32 08:58:08 12/18/12 from what I remember, Ash runs absurdly tight clearances - aliaZ 09:22:21 12/19/12
Post a Followup	You cannot reply to this message because you are not logged in.