Subject	Re: Did you get coated bearings from Mitch?
Posted by	94ttz32 on December 18, 2012 at 8:27 AM
	This message has been viewed 126 times.
In Reply To	Did you get coated bearings from Mitch? posted by ZXoltan on December 18, 2012 at 07:49 AM
Message	When you make a lot of power or drive the car very hard boost will push down on the rod creating wear on the bearing. Ash does the same thing to his car that he built him self. That's one reason you hear of engines spinning bearing is they become wore. http://a5.sphotos.ak.fbcdn.net/hphotos-ak-ash4/460260_456597067700142_1938695651_o.jpg
Follow Ups	A and half year review on my built Engine from EP RACING - 94ttz32 21:02:35 12/17/12 I didn't read anything you wrote, I just wanted to comment - inf 21:17:47 12/17/12 Re: I didn't read anything you wrote, I just wanted to comment - 94ttz32 21:23:58 12/17/12 How many miles did you put the engine since the build? - BlitZ91TT 21:22:43 12/17/12 Re: How many miles did you put the engine since the build? - 94ttz32 21:28:02 12/17/12 Thanks! Mitch and I go way back. Good to know - BlitZ91TT 08:25:49 12/18/12 Glad to hear more and more good posts about EP Racing.. - KongZTT GT28RS MD 23:08:17 12/17/12 is this a positive or negative review? (n/m) - ZiNnYc 06:40:03 12/18/12 Re: is this a positive or negative review? - 94ttz32 06:56:41 12/18/12 Re: Re: is this a positive or negative review? - 94ttz32 07:06:47 12/18/12 What is a smother of 5 ? (n/m) - jlag 07:42:01 12/18/12 A mathematical factor in the dyno software used - boileralum 07:58:18 12/18/12 Thanks (n/m) - jlag 08:01:05 12/18/12 Did you get coated bearings from Mitch? - ZXoltan 07:49:59 12/18/12 Re: Did you get coated bearings from Mitch? - 94ttz32 08:27:52 12/18/12 OK...and what about the coatings? Any info on how they hold - ZXoltan 08:38:30 12/18/12 Re: OK...and what about the coatings? Any info on how they hold - 94ttz32 08:58:08 12/18/12 from what I remember, Ash runs absurdly tight clearances - aliaZ 09:22:21 12/19/12
Post a Followup	You cannot reply to this message because you are not logged in.