Subject	Did you get coated bearings from Mitch?
Posted by	ZXoltan on December 18, 2012 at 7:49 AM
	This message has been viewed 143 times.
In Reply To	A and half year review on my built Engine from EP RACING posted by 94ttz32 on December 17, 2012 at 09:02 PM
Message	Wondering how his coatings hold up... figured you would only know about the bearings since you replaced them already. Still not quite sure why bearings would need replacement within 15k miles unless there was something wrong with them...?
Follow Ups	A and half year review on my built Engine from EP RACING - 94ttz32 21:02:35 12/17/12 I didn't read anything you wrote, I just wanted to comment - inf 21:17:47 12/17/12 Re: I didn't read anything you wrote, I just wanted to comment - 94ttz32 21:23:58 12/17/12 How many miles did you put the engine since the build? - BlitZ91TT 21:22:43 12/17/12 Re: How many miles did you put the engine since the build? - 94ttz32 21:28:02 12/17/12 Thanks! Mitch and I go way back. Good to know - BlitZ91TT 08:25:49 12/18/12 Glad to hear more and more good posts about EP Racing.. - KongZTT GT28RS MD 23:08:17 12/17/12 is this a positive or negative review? (n/m) - ZiNnYc 06:40:03 12/18/12 Re: is this a positive or negative review? - 94ttz32 06:56:41 12/18/12 Re: Re: is this a positive or negative review? - 94ttz32 07:06:47 12/18/12 What is a smother of 5 ? (n/m) - jlag 07:42:01 12/18/12 A mathematical factor in the dyno software used - boileralum 07:58:18 12/18/12 Thanks (n/m) - jlag 08:01:05 12/18/12 Did you get coated bearings from Mitch? - ZXoltan 07:49:59 12/18/12 Re: Did you get coated bearings from Mitch? - 94ttz32 08:27:52 12/18/12 OK...and what about the coatings? Any info on how they hold - ZXoltan 08:38:30 12/18/12 Re: OK...and what about the coatings? Any info on how they hold - 94ttz32 08:58:08 12/18/12 from what I remember, Ash runs absurdly tight clearances - aliaZ 09:22:21 12/19/12
Post a Followup	You cannot reply to this message because you are not logged in.