Subject	Wear indicators are meant to go on the BACK side of rotors (n/m)
Posted by	Bernie (NoVA) on December 17, 2012 at 9:23 PM
	This message has been viewed 148 times.
In Reply To	Mattz's 12.2" rotor upgrade installed posted by cherryz on December 17, 2012 at 07:27 PM
Message
Follow Ups	Mattz's 12.2" rotor upgrade installed - cherryz 19:27:49 12/17/12 Re: Mattz's 12.2" rotor upgrade installed - wild_maxx 19:42:58 12/17/12 I suppose, but have never installed them on inside before. (n/m) - cherryz 20:13:27 12/17/12 That doesn't change the fact thats where they belong (n/m) - Bernie (NoVA) 21:24:40 12/17/12 Got it. Seems easier to inspect if on outside. (n/m) - cherryz 22:58:54 12/17/12 That's why they make noise... (n/m) - BlackholeZ 23:41:15 12/17/12 They are noise makers for the side you can't see. (n/m) - Bernie (NoVA) 08:51:06 12/18/12 I'm pretty sure this kit was not designed to cut - ForceFedTT (SoCal) 19:57:26 12/17/12 As stated the wear tab should be on the in board side. (n/m) - white22sky 21:17:14 12/17/12 Wear indicators are meant to go on the BACK side of rotors (n/m) - Bernie (NoVA) 21:23:41 12/17/12 "Occupation: Engineer" hehehe =) (n/m) - The Hawk 21:39:27 12/17/12 A 5 second google search for 'mattz rotor upgrade' gives - boileralum 22:22:59 12/17/12 Will be swapping the wear tabs to inside, thx for the help. (n/m) - cherryz 22:48:13 12/17/12
Post a Followup	You cannot reply to this message because you are not logged in.