Subject	You are going to need an alignment if you adjust
Posted by	ttsmokin on December 08, 2012 at 1:02 PM
	This message has been viewed 85 times.
In Reply To	SPL V3 tension rods.... posted by Z ONLY1 on December 08, 2012 at 12:09 PM
Message	May I ask what you would be adjusting the tension rods without being on an alignment rack for? Anytime you touch any suspension component you are going to mess up your alignment. Even raising/lowering coilovers. I went onto SPL site and it says the rod is 1 3/8" itself, one of the nuts looks larger and one slightly smaller. You should probably be in the range of 1"- 1-1/2" wrenches. Could be metric tho, you can always grab a pair of vernier calipers and measure the nuts first.
Follow Ups	SPL V3 tension rods.... - Z ONLY1 12:09:57 12/08/12 You are going to need an alignment if you adjust - ttsmokin 13:02:58 12/08/12 Yea, I know....just finished alot of stuff..... - Z ONLY1 14:18:37 12/08/12 Re: SPL V3 tension rods.... - njz 13:14:22 12/08/12 yup..presently my largest crescent wrench still too small... (n/m) - Z ONLY1 14:20:25 12/08/12 man major brain embolism....forgot I had just purchased... - Z ONLY1 14:22:48 12/08/12 for future searchers, please post the result. (n/m) - BlackholeZ 03:12:53 12/09/12 2nd (n/m) - KongZTT GT28RS MD 10:59:20 12/09/12 I will....as soon as I get off my ass and do it.... - Z ONLY1 15:19:15 12/09/12 http://www.splparts.com/chassis-Z32.html#SPLWRENCH - Bernie (NoVA) 17:59:16 12/09/12 I really wish i bought that wrench.I messed up the nuts w/o - TTNickSoCal 16:57:36 12/10/12
Post a Followup	You cannot reply to this message because you are not logged in.