Subject	Yes, but..........
Posted by	TTZEDHEAD on November 25, 2012 at 8:10 PM
	This message has been viewed 125 times.
In Reply To	z1 throttle bodies posted by AddictedToBoost on November 25, 2012 at 07:50 PM
Message	If the factory TBs are working properly, just wait till the plenum is off. The additional turbulence and the actual restriction I suspect, will negate any gains. Keep in mind, that the TBs work as part of an overall system that is held back by its weakest point. That said, I think it's been discussed that the gains from larger TBs are nominal at best, but they are there. I just think that the porting is, if any, a lot of the affect.
Follow Ups	z1 throttle bodies - AddictedToBoost 19:50:16 11/25/12 Yes, but.......... - TTZEDHEAD 20:10:33 11/25/12 how is the valving going to clear the smaller hole - LJZTT 20:57:45 11/25/12 Thats really the point I was making - TTZEDHEAD 22:13:07 11/25/12 assuming they even fit, it is a waste of time - aliaZ 21:08:40 11/25/12 No. Butterfly valve will hit the plenum...why? (n/m) - ConVerTT 21:14:57 11/25/12 Forgot about that, I stand corrected (n/m) - TTZEDHEAD 22:00:21 11/25/12 Re: No. Butterfly valve will hit the plenum...why? - AddictedToBoost 22:24:23 11/25/12 Tapered 2.5" to 2" couplers are available. (n/m) - Evan(CA) 23:27:55 11/25/12 Re: Tapered 2.5" to 2" couplers are available. - AddictedToBoost 01:51:17 11/26/12
Post a Followup	You cannot reply to this message because you are not logged in.