TwinTurbo.NET: Nissan 300ZX forum - Yes, the turns will need a good amount of cutting...
People Seeking Info
 
   


     
Subject Yes, the turns will need a good amount of cutting...
     
Posted by BoneZ (MD) on November 19, 2012 at 5:57 PM
  This message has been viewed 144 times.
     
In Reply To Looking for some Z advice in multiple departments posted by blackomega on November 19, 2012 at 05:41 PM
     
Message
But your ICs look like they are sitting low and too far to the outside.

Where are your ducts?

I managed to get everything in place with the same facsia with Ash's pipe kit.

-___________________________________________________________-

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.