Subject	Well then follow the installation guide and do this:
Posted by	Multi_Read (MO) on November 14, 2012 at 1:57 AM
	This message has been viewed 107 times.
In Reply To	everything is in there correctly. posted by RonDeezy on November 14, 2012 at 01:29 AM
Message	"AFTER INSTALLATION CHECK CLEARANCE BETWEEN DRIVESHAFT AND BOTTOM OF SHIFTER. You should have aprrox 3/8” minimum clearance. If you do not contact us."
Follow Ups	z1 short shifter and Z speed solid brace installed and now - RonDeezy 21:08:40 11/13/12 There is no way that's happening if everything is installed - Multi_Read (MO) 00:39:43 11/14/12 everything is in there correctly. - RonDeezy 01:29:31 11/14/12 Well then follow the installation guide and do this: - Multi_Read (MO) 01:57:09 11/14/12 a couple of days ago when it was installed everything was - RonDeezy 02:12:20 11/14/12 the bracket is installed on top where it belongs. - RonDeezy 02:40:53 11/14/12 OK, then... - MidLifeZ (DFW) 06:22:59 11/14/12 No, call Joe@ZSpeedPerformance. It's his bracket. (n/m) - Multi_Read (MO) 14:22:01 11/14/12 Highly improbable that the issue is the stamped bracket. - Bernie (NoVA) 14:52:19 11/14/12 No no, I meant it's Joe's bracket so don't call Z1. (n/m) - Multi_Read (MO) 01:48:13 11/15/12 TPIUWP (n/m) - TTZEDHEAD 06:05:58 11/14/12 I've had that happen before - aliaZ 06:24:04 11/14/12 Grab your shifter, and pull it up fairly hard. - JMW300ZX 08:58:15 11/14/12 you hit the nail on the head jmw. - RonDeezy 14:05:49 11/14/12 Wow! I hadn't heard about that issue. Thanks for the info. (n/m) - ConVerTT 17:47:45 11/14/12
Post a Followup	You cannot reply to this message because you are not logged in.