Subject	Splicing o2 sensor connector....
Posted by	91z tt on November 12, 2012 at 9:19 PM
	This message has been viewed 176 times.
Message	My right side o2 connector completely cracked and the wires are in bad shape 6" back from the connector to the harness. I don't think I have a signal ( ConZult o2 sensor reading is 32~33 also tested it with Autometer 02 gauge (no lights - period), idle is a bit rough) What's interesting is I'm NOT throwing a code so I don't think I have complete sensor failure. I want to splice in a new connector. My questions are; first, the signal wire appears to be shielded. Will I have any issues splicing? Any tips? Second, can I source these from one of the vendors or is a trp to the boneyard in my immediate future? TIA.
Follow Ups	Splicing o2 sensor connector.... - 91z tt 21:19:44 11/12/12 don't splice O2's, replace it with a new oem one. (n/m) - Ghoztt 01:40:40 11/13/12 The damage is on the harness side. (n/m) - 91z tt 06:33:34 11/13/12 Re: The damage is on the harness side. - njz 07:21:22 11/13/12 YGM (n/m) - 91z tt 09:25:47 11/13/12 Ahh, I misunderstood. Harness side is ok to splice if done - Ghoztt 12:18:19 11/13/12 It's not shielded - it's stainless due to heat ranges. (n/m) - Bernie (NoVA) 09:25:12 11/13/12 Got it - thanks Bernie!!! (n/m) - 91z tt 09:26:51 11/13/12
Post a Followup	You cannot reply to this message because you are not logged in.