Subject	It's trival, you drill and tap 9 holes. (n/m)
Posted by	Bernie (NoVA) on November 11, 2012 at 9:35 PM
	This message has been viewed 123 times.
In Reply To	How much does it cost to have a flywheel machined posted by boileralum on November 11, 2012 at 05:49 PM
Message
Follow Ups	TT.net - Help me pick a clutch for my Z - boileralum 22:43:46 11/10/12 The multi disc clutches are loud - TTZEDHEAD 23:06:16 11/10/12 Hi 5 in here. (n/m) - arrowenterprises 20:14:10 11/11/12 OSG - Baller Rattle! - ZinnZ32 16:38:46 11/12/12 I've done quite a few RPS and SB clutches - BOOZTD 3 23:14:26 11/10/12 I have used the High 5 with RPS / SZ flywheel - Boosted1 09:32:19 11/11/12 SZ high 5 puk kit (n/m) - FairladyProject93 04:48:56 11/11/12 Contact Joe at Southbend - Drk93TT 08:03:57 11/11/12 Re: Contact Joe at Southbend - njz 07:00:23 11/12/12 SZ Hi-5 (n/m) - ali300zx 09:20:44 11/11/12 2nd... technically 3rded. That clutch feels like stock. (n/m) - PiotrC70 12:15:45 11/11/12 650-700hp? You're finally installing that OG turbo kit! - Aqualung 10:18:36 11/11/12 Yeah, figure I may as well at least try them out. - boileralum 10:52:06 11/11/12 This needs a home ... - Bernie (NoVA) 12:34:46 11/11/12 Thats the 1st SB clutch I had. It was Excellent. - Drk93TT 14:51:31 11/11/12 How much does it cost to have a flywheel machined - boileralum 17:49:38 11/11/12 It's trival, you drill and tap 9 holes. (n/m) - Bernie (NoVA) 21:35:31 11/11/12 Makes me wish my clutch would go out... (n/m) - TriniTT 11:14:28 11/12/12 Re: TT.net - Help me pick a clutch for my Z - AwesomeZ32 18:46:38 11/11/12 Hi-5 - Zu4ea 19:50:08 11/11/12 Hi-5 is great at high rpm but - ConVerTT 09:53:57 11/12/12 Re: TT.net - Help me pick a clutch for my Z - Rob260 16:53:52 11/12/12 email me...i have a clutch that you might like - genic 19:54:45 11/12/12 I emailed you, check your messages :) (n/m) - boileralum 22:10:45 11/13/12
Post a Followup	You cannot reply to this message because you are not logged in.