Subject	here are some pics of the sleeves.
Posted by	RonDeezy on October 28, 2012 at 2:15 AM
	This message has been viewed 375 times.
In Reply To	so Z1 sent me an updated ptu bracket,...but... posted by RonDeezy on October 28, 2012 at 01:42 AM
Message	left is stock, right is from the z1 short throw. now a pic from the top.left is stock,right is z1. (pivot bolt fits in the z1 sleeve on this side in the pic below) this pic shows the other side of the z1 sleeve compared to the stock(again z1 is on the right).its obvious looking at it from this side that it is not the same as its opposite end. ive searched and it seems im the only one thats had this problem. id like to resolve this quickly seeing how my transmission is on a jack atm. i removed the cross member to be able to more easily remove my old shifter brace to swap with the zspeed i got with the short throw(in doing so also found my tranny mount was crap so i was gonna replace that with a new one i have).but now with this sleeve issue, im at a stand still. blows after already workin on it for a couple hours.
Follow Ups	so Z1 sent me an updated ptu bracket,...but... - RonDeezy 01:42:57 10/28/12 here are some pics of the sleeves. - RonDeezy 02:15:56 10/28/12 Did u call Z1 yet? - ZXoltan 06:06:25 10/28/12 it was 12:30 at night when i ran into the problem. - RonDeezy 06:57:32 10/28/12 just realized.. - RonDeezy 08:21:34 10/28/12 Yes, I do too. (n/m) - Zblackbeast 10:53:35 10/28/12 i also have one in a box that i haven't installed yet. (n/m) - slayer fan 13:37:31 10/28/12
Post a Followup	You cannot reply to this message because you are not logged in.