Subject	so Z1 sent me an updated ptu bracket,...but...
Posted by	RonDeezy on October 28, 2012 at 1:42 AM
	This message has been viewed 279 times.
Message	now im finding as im trying to install the z1 short shifter i purchased, that the pivot bolt that was in my car holding the shifter to the linkage doesnt fit through the sleeve on the new short throw.whats even stranger is that the bolt fits in one side of the sleeve but not the other.like it wont go all the way through..can anyone help me?or explain why this z1 short shifter has a tapered sleeve??
Follow Ups	so Z1 sent me an updated ptu bracket,...but... - RonDeezy 01:42:57 10/28/12 here are some pics of the sleeves. - RonDeezy 02:15:56 10/28/12 Did u call Z1 yet? - ZXoltan 06:06:25 10/28/12 it was 12:30 at night when i ran into the problem. - RonDeezy 06:57:32 10/28/12 just realized.. - RonDeezy 08:21:34 10/28/12 Yes, I do too. (n/m) - Zblackbeast 10:53:35 10/28/12 i also have one in a box that i haven't installed yet. (n/m) - slayer fan 13:37:31 10/28/12
Post a Followup	You cannot reply to this message because you are not logged in.