Subject	Re: Crankshaft has been balanced... should I install UR pulley?
Posted by	soulpwr on October 20, 2012 at 3:57 PM
	This message has been viewed 134 times.
In Reply To	Re: Crankshaft has been balanced... should I install UR pulley? posted by KA8 on October 20, 2012 at 11:22 AM
Message	They are supposed to be balanced during production just like flywheels but I never assume aftermarket parts to be ready to run without checking them. I've seen new factory pulleys that weren't properly balanced out of the box
Follow Ups	Crankshaft has been balanced... should I install UR pulley? (n/m) - Jiro 02:13:41 10/20/12 what are your concerns? - aliaZ 06:17:16 10/20/12 If it was my Z I would say no. A lot of people like them - Piranha 10:55:51 10/20/12 Did you have the pulley balanced with the crank? (n/m) - soulpwr 11:09:46 10/20/12 not sure looking back on the receipt from the previous owner - Jiro 16:09:26 10/20/12 OEM pulleys are interchangable, they are not balanced - zellamay 18:04:51 10/20/12 Re: Crankshaft has been balanced... should I install UR pulley? - KA8 11:22:31 10/20/12 Re: Crankshaft has been balanced... should I install UR pulley? - soulpwr 15:57:57 10/20/12 If there isn't an emblem etched on it anywhere then - Zvil 19:54:43 10/20/12 NOOO is my opinion - Zvil 19:52:47 10/20/12 Is it a UR pulley? Zvil has a point, above. If it's not - zellamay 20:09:29 10/20/12
Post a Followup	You cannot reply to this message because you are not logged in.