Subject	If it was my Z I would say no. A lot of people like them
Posted by	Piranha on October 20, 2012 at 10:55 AM
	This message has been viewed 109 times.
In Reply To	Crankshaft has been balanced... should I install UR pulley? (n/m) posted by Jiro on October 20, 2012 at 02:13 AM
Message	though. An ATI pulley IMHO is the only way to go :)
Follow Ups	Crankshaft has been balanced... should I install UR pulley? (n/m) - Jiro 02:13:41 10/20/12 what are your concerns? - aliaZ 06:17:16 10/20/12 If it was my Z I would say no. A lot of people like them - Piranha 10:55:51 10/20/12 Did you have the pulley balanced with the crank? (n/m) - soulpwr 11:09:46 10/20/12 not sure looking back on the receipt from the previous owner - Jiro 16:09:26 10/20/12 OEM pulleys are interchangable, they are not balanced - zellamay 18:04:51 10/20/12 Re: Crankshaft has been balanced... should I install UR pulley? - KA8 11:22:31 10/20/12 Re: Crankshaft has been balanced... should I install UR pulley? - soulpwr 15:57:57 10/20/12 If there isn't an emblem etched on it anywhere then - Zvil 19:54:43 10/20/12 NOOO is my opinion - Zvil 19:52:47 10/20/12 Is it a UR pulley? Zvil has a point, above. If it's not - zellamay 20:09:29 10/20/12
Post a Followup	You cannot reply to this message because you are not logged in.