Subject	Re: Intercooler design
Posted by	Doug71zt(CAN) on October 15, 2012 at 12:34 PM
	This message has been viewed 155 times.
In Reply To	Intercooler design posted by JMartz on October 15, 2012 at 09:34 AM
Message	Why not just weld an air guide in the inlet to deflect a portion of the flow to the top half of the IC?
Follow Ups	Intercooler design - JMartz 09:34:58 10/15/12 How will youpackage that ? (n/m) - ztunerz 09:41:02 10/15/12 Easy, one side the same as stock, the other - JMartz 12:33:36 10/15/12 Shhh damnit, i had the same idea, i even measured it up... (n/m) - ztunerz 20:49:45 10/15/12 I know someone has been working on that, maybe they - toykoz32 11:29:05 10/15/12 Re: Intercooler design - Doug71zt(CAN) 12:34:16 10/15/12 A reasonable idear! - JMartz 12:37:29 10/15/12 internal air guides are common on commercial trucks (n/m) - aliaZ 17:16:09 10/15/12 I don't think you're right about the 80/20 thing. Since - zellamay 13:09:20 10/15/12 I have always thought like you but in addition - JMartz 13:22:53 10/15/12 I remember that too, but that has to do with cycles, - zellamay 14:13:54 10/15/12 Equal pressure does not mean equal flow. (n/m) - coma_ass 13:42:25 10/15/12 Explain, please. Seems to me that, at idle, the air - zellamay 14:21:55 10/15/12 Not sure how to properly explain it. - coma_ass 13:14:55 10/16/12 If the IC core is uniform, equal pressure at the entry point - black300zx 16:20:07 10/15/12 Uniform, equal pressure at the entry tank will - JMartz 17:19:17 10/15/12 They are all "cross flow" - Brad(RI) 14:36:13 10/15/12 Sorry bad choice of words. I am not discussing ICs - JMartz 17:29:53 10/15/12
Post a Followup	You cannot reply to this message because you are not logged in.