Subject	Something else to think about before attaching the
Posted by	jzack on October 07, 2012 at 1:52 PM
	This message has been viewed 211 times.
In Reply To	fail posted by RonDeezy on October 07, 2012 at 03:20 AM
Message	engine to the stand. I bolted an aluminum piece of flat bar stock (2ft long or so) into that rear hub. Once the engine was up on the stand - made it easy to immobilize the crank shaft from turning. Pretty sure I did it across 2 of the bolt holes...been a while.... Really depends on what you are doing with the engine once it's mounted?....
Follow Ups	fail - RonDeezy 03:20:08 10/07/12 Re: fail - MaxxAction 06:19:50 10/07/12 Pretty common with all engine stands. (n/m) - MixManMash 06:44:58 10/07/12 Yes... Go to the local parts store and buy some longer bolts - Zski 08:31:39 10/07/12 If I were you, I'd make sure they were high grade. (n/m) - evan_aggie 10:35:11 10/07/12 isn’t that obvious? (n/m) - Zski 19:48:12 10/07/12 Yes, high grade would be wise >_< - Coldfusown 12:03:36 10/07/12 had this happen to me a few days ago - Stanky 12:36:44 10/07/12 Re: had this happen to me a few days ago - RonDeezy 14:16:59 10/07/12 Re: had this happen to me a few days ago - RonDeezy 23:51:00 10/07/12 lol might as well use the bolts since you bought them - Stanky 03:12:30 10/08/12 Something else to think about before attaching the - jzack 13:52:36 10/07/12 thanks for all the info guys. - RonDeezy 14:14:21 10/07/12
Post a Followup	You cannot reply to this message because you are not logged in.