Subject	fail
Posted by	RonDeezy on October 07, 2012 at 3:20 AM
	This message has been viewed 941 times.
Message	so i bought an engine stand to mount my block to along with a tranny bolt set. however, when i went to bolt up, i realized the bolts were too short.well all except for 1 tranny bolt.i found two other longer bolts in a bucket i have but im still one short.i was wondering if anyone else has had an experience using an autozone engine stand.i'll try to put a pic below showin yall what im talkin about.but ya, first timer here.ha
Follow Ups	fail - RonDeezy 03:20:08 10/07/12 Re: fail - MaxxAction 06:19:50 10/07/12 Pretty common with all engine stands. (n/m) - MixManMash 06:44:58 10/07/12 Yes... Go to the local parts store and buy some longer bolts - Zski 08:31:39 10/07/12 If I were you, I'd make sure they were high grade. (n/m) - evan_aggie 10:35:11 10/07/12 isn’t that obvious? (n/m) - Zski 19:48:12 10/07/12 Yes, high grade would be wise >_< - Coldfusown 12:03:36 10/07/12 had this happen to me a few days ago - Stanky 12:36:44 10/07/12 Re: had this happen to me a few days ago - RonDeezy 14:16:59 10/07/12 Re: had this happen to me a few days ago - RonDeezy 23:51:00 10/07/12 lol might as well use the bolts since you bought them - Stanky 03:12:30 10/08/12 Something else to think about before attaching the - jzack 13:52:36 10/07/12 thanks for all the info guys. - RonDeezy 14:14:21 10/07/12
Post a Followup	You cannot reply to this message because you are not logged in.