Subject	Re: The end links should be 90 degrees to the bar
Posted by	MaxxAction on October 04, 2012 at 5:17 PM
	This message has been viewed 153 times.
In Reply To	The end links should be 90 degrees to the bar posted by Broke_as_**** on October 04, 2012 at 04:58 PM
Message	Check out these bad boys. http://m.youtube.com/watch?v=udv6aanuW2o
Follow Ups	Can someone who is good with suspension explain something? - MaxxAction 13:59:02 10/04/12 What are you tightening? (n/m) - BigTDogg (MA) 14:15:32 10/04/12 Re: What are you tightening? - MaxxAction 14:30:36 10/04/12 So the bolt/nut going through the swaybar? I locktited - BigTDogg (MA) 14:37:10 10/04/12 You don't want to tighten them as tight as they will go" - dogpile 15:02:28 10/04/12 Ah, yeah, just looked at the CZP end links - BigTDogg (MA) 15:27:05 10/04/12 Nylock nuts only "lock" for the first few times you tighten - RonZ300 (Socal) 15:38:30 10/04/12 Right, but they don't back off on their own. - BigTDogg (MA) 16:16:31 10/04/12 Re: Ah, yeah, just looked at the CZP end links - MaxxAction 17:39:59 10/04/12 Check the heim joint - Broke_as_**** 15:21:38 10/04/12 Re: Check the heim joint - MaxxAction 16:43:47 10/04/12 The end links should be 90 degrees to the bar - Broke_as_**** 16:58:37 10/04/12 Re: The end links should be 90 degrees to the bar - MaxxAction 17:17:56 10/04/12 Re: Check the heim joint - MaxxAction 16:49:28 10/04/12
Post a Followup	You cannot reply to this message because you are not logged in.