Subject	Right, but they don't back off on their own.
Posted by	BigTDogg (MA) on October 04, 2012 at 4:16 PM
	This message has been viewed 118 times.
In Reply To	Nylock nuts only "lock" for the first few times you tighten posted by RonZ300 (Socal) on October 04, 2012 at 03:38 PM
Message	But if you back them off, well you're SOL. One company you should never buy from Z32 Enthusiast Group On FB "I was way more timid then than I am now about getting in there and yanking on things." - TT XTZ 13:30:34 07/25/05 "...Downpipes own. I love them...I shall name my first-born after them with glee..." - SeedyRom 05:13:20 10/03/02 "Just ran out to get some knee pads. I'm ready now... BRING.....IT.....ON... :-) " - Dave N 19:04:30 10/31/07 "Either ignore him or beat him up. Anything else will be over his head." - Marshall 12:28:23 08/18/04 "I hope you get fucked in the ass with a pringles can." - ni[X]it 14:53:53 02/02/06 "I'm glad I have the MSP mani's." - jschrauwen 22:20:13 06/10/08 "i love the cock" - genic 22:20:47 09/25/03
Follow Ups	Can someone who is good with suspension explain something? - MaxxAction 13:59:02 10/04/12 What are you tightening? (n/m) - BigTDogg (MA) 14:15:32 10/04/12 Re: What are you tightening? - MaxxAction 14:30:36 10/04/12 So the bolt/nut going through the swaybar? I locktited - BigTDogg (MA) 14:37:10 10/04/12 You don't want to tighten them as tight as they will go" - dogpile 15:02:28 10/04/12 Ah, yeah, just looked at the CZP end links - BigTDogg (MA) 15:27:05 10/04/12 Nylock nuts only "lock" for the first few times you tighten - RonZ300 (Socal) 15:38:30 10/04/12 Right, but they don't back off on their own. - BigTDogg (MA) 16:16:31 10/04/12 Re: Ah, yeah, just looked at the CZP end links - MaxxAction 17:39:59 10/04/12 Check the heim joint - Broke_as_**** 15:21:38 10/04/12 Re: Check the heim joint - MaxxAction 16:43:47 10/04/12 The end links should be 90 degrees to the bar - Broke_as_**** 16:58:37 10/04/12 Re: The end links should be 90 degrees to the bar - MaxxAction 17:17:56 10/04/12 Re: Check the heim joint - MaxxAction 16:49:28 10/04/12
Post a Followup	You cannot reply to this message because you are not logged in.