Subject	Re: What are you tightening?
Posted by	MaxxAction on October 04, 2012 at 2:30 PM
	This message has been viewed 122 times.
In Reply To	What are you tightening? (n/m) posted by BigTDogg (MA) on October 04, 2012 at 02:15 PM
Message	I tried to tighten the end links... But evidently these were made faulty from the beginning because they have to be removed to adjust. They should have one end that is left threaded, and one that is right, but they are both right, so they gotta be disassembled to be adjusted. I first pulled them as tight as they would go, because the sway bar was kinda "loose" I could move it with my hands. What I did last night was lengthen them.
Follow Ups	Can someone who is good with suspension explain something? - MaxxAction 13:59:02 10/04/12 What are you tightening? (n/m) - BigTDogg (MA) 14:15:32 10/04/12 Re: What are you tightening? - MaxxAction 14:30:36 10/04/12 So the bolt/nut going through the swaybar? I locktited - BigTDogg (MA) 14:37:10 10/04/12 You don't want to tighten them as tight as they will go" - dogpile 15:02:28 10/04/12 Ah, yeah, just looked at the CZP end links - BigTDogg (MA) 15:27:05 10/04/12 Nylock nuts only "lock" for the first few times you tighten - RonZ300 (Socal) 15:38:30 10/04/12 Right, but they don't back off on their own. - BigTDogg (MA) 16:16:31 10/04/12 Re: Ah, yeah, just looked at the CZP end links - MaxxAction 17:39:59 10/04/12 Check the heim joint - Broke_as_**** 15:21:38 10/04/12 Re: Check the heim joint - MaxxAction 16:43:47 10/04/12 The end links should be 90 degrees to the bar - Broke_as_**** 16:58:37 10/04/12 Re: The end links should be 90 degrees to the bar - MaxxAction 17:17:56 10/04/12 Re: Check the heim joint - MaxxAction 16:49:28 10/04/12
Post a Followup	You cannot reply to this message because you are not logged in.