Subject	is that what is causing the perpetual low squeal??
Posted by	LJZTT on September 28, 2012 at 6:48 AM
	This message has been viewed 216 times.
In Reply To	Getting a new alty belt just right - no squeeling.... (n/m) posted by jzack on September 27, 2012 at 06:13 PM
Message	I have had this going on since the 120k job. Could not figure out which belt it was since they all feel fine, but one of them is squealing ever so slightly but constantly. It does seem to ramp up a bit when I turn on lights or hold the brakes, so I guess that should have been the clue now that I think about it. "Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery." --Winston Churchill "The last official act of any government is to loot the treasury." --George Washington END THE FED ....learn why, in 42 minutes Full Pardon for PFC Bradley Manning
Follow Ups	What Annoys the Hell Out of you Working on the Z? - ZXRider 12:40:40 09/27/12 Trying to fit under the pass side dash to remove the AC Evap (n/m) - whip 12:45:41 09/27/12 ... or the heater core. (n/m) - Shiers69 13:11:24 09/27/12 My wife yelling, "When are you gonna stop working on - zellamay 13:21:41 09/27/12 hahahaha 2nd - mikehawkhertz 13:49:18 09/27/12 rofl... cause it's true. (n/m) - spicyZ 14:07:34 09/27/12 they don't seem to understand the therapeutic value - aliaZ 06:53:29 09/28/12 Feeling like I just opened the hood and got my hands dirty.. - gizmo 13:34:09 09/27/12 ^^ big 2nd ^^ (n/m) - white22sky 16:29:57 09/27/12 working on the z. (n/m) - fuzzymonkey 13:44:03 09/27/12 Breaking brittle connectors. Otherwise, not too much. (n/m) - Z1 ZONLY 13:47:27 09/27/12 That I am working on it and not driving it. (n/m) - RaeCathode 14:01:14 09/27/12 Small garage. (n/m) - BoneZ (MD) 14:05:36 09/27/12 No garage - Krazyd27(Houston) 14:12:35 09/27/12 if you drive the car forward, you'll be in the garage (n/m) - fuzzymonkey 14:53:43 09/27/12 False. I would go straight into the house - Krazyd27(Houston) 15:01:36 09/27/12 AND THEN you'd have a garage :D (n/m) - fuzzymonkey 15:21:56 09/27/12 Haha and one hell of a house repair bill D: (n/m) - Krazyd27(Houston) 15:56:12 09/27/12 Please tell me you don't go under the car with only a jack - Aqualung 16:05:57 09/27/12 No sir, I was inspecting the tires before I went to the - Krazyd27(Houston) 16:44:31 09/27/12 Forgot to include pic in previous post - Krazyd27(Houston) 16:48:51 09/27/12 ^2nd. small garage = no big projects. (n/m) - 90TT Zfan (E.Tenn) 14:50:16 09/27/12 It can be done! I've built whole cars in a tiny 1 car garage - Jayru 14:58:06 09/27/12 Pussy, George did his swap in a garage with a foot on each - BigTDogg (MA) 12:52:30 09/28/12 Dropping anything. - TriniTT 14:14:15 09/27/12 checking fuses in driver footwell! - MidLifeZ (DFW) 14:30:34 09/27/12 God forbid, the relays BEHIND the fuse box - fuzzymonkey 14:55:31 09/27/12 Removing an SPL Radiator - ZinnZ32 14:58:03 09/27/12 Ugh, you just made me not look forward to installing mine - Jayru 15:00:31 09/27/12 Well, there were many swear words involved... - ZinnZ32 15:43:57 09/27/12 Ouch! Did your motor mount fail or something? - Jayru 16:04:40 09/27/12 No, it's just how it fit. Barley any clearance with piping - ZinnZ32 17:40:06 09/27/12 Will do. Thanks! (n/m) - Jayru 21:51:20 09/27/12 Jacques your car high enough, and install the rad from - fuzzymonkey 15:25:17 09/27/12 Ever tried to re-nylon the antenna mast? - Stokens (StoMoZTT) 15:35:43 09/27/12 Try to adjust the clutch pedal on a RHD Z (n/m) - ArubaDave 16:02:00 09/27/12 Why? It takes me hours to adjust a LHD Z :D (n/m) - MrOzzie5183 16:24:25 09/27/12 LHD Z tthe clutch is the closest to the door - BlackholeZ 16:58:33 09/27/12 Rear main seal and tranny stabbin'! Effin trannies :-( (n/m) - ConVerTT 17:57:39 09/27/12 2nd that, miserable b!tches (n/m) - vorpalZ 21:36:27 09/27/12 Re: Rear main seal and tranny stabbin'! Effin trannies :-( - gt300zxtt(HI) 03:28:45 09/28/12 That is a good idea (n/m) - ConVerTT 10:19:49 09/28/12 I also use studs for tranny stabbing - aliaZ 18:40:38 09/28/12 Getting a new alty belt just right - no squeeling.... (n/m) - jzack 18:13:42 09/27/12 is that what is causing the perpetual low squeal?? - LJZTT 06:48:43 09/28/12 T-Top mouldings, slicktop mouldings, when youve had your - Dane (Houston) 20:13:55 09/27/12 The clips that hold the trim piece just over the stereo - Spectrum (WI) 22:25:13 09/27/12 Having to drive all the way back to Omaha for a place to - Piranha 23:09:03 09/27/12 Denver is closer :) (n/m) - Woody75 (Denver) 11:28:30 09/28/12 Efi harness cover in the cabin tucked behind the evap - gt300zxtt(HI) 03:39:09 09/28/12 ...finding someone that can actually work on the car (n/m) - SuparexTT 11:16:27 09/28/12
Post a Followup	You cannot reply to this message because you are not logged in.