Subject	17in spare tire space saver supra? for BBK z32 cars
Posted by	Dane (Houston) on September 27, 2012 at 5:19 PM
	This message has been viewed 541 times.
Message	I recently had a blow out on the front and it was not pleasant. I've been looking for solutions for a spare tire that fits in a 2 seater z32 which is a space saver and will fit over my AP 13 inch kit and possibly my 13.5 kit too. I recalled that the supra had slightly larger front brakes than Z32 and 17inch wheels factory. So I searched and found that they have 17inch collapsible space saver spares that just might be a solution. Im not sure if the 1inch difference will allow it to fit in the spare tire compartment. La-Z-Link So can just move the rears to front but usually not when you have 275s or 9.5+ wide wheels it usually doesn't clear the suspension. If there are any supra owners on here we could find the ID up the supra spare tire. and use this info to see if it would work out. 13 inch kits [ http://www.stillen.com/product_files/30-1100~profile.pdf ] 13.5 kits [ http://www.stillen.com/product_files/AP1100~profile.pdf ] Houston Z www.houston-nissans.com
Follow Ups	17in spare tire space saver supra? for BBK z32 cars - Dane (Houston) 17:19:39 09/27/12 im guessing if the tire collapses the same it will fit - Antihero 18:03:38 09/27/12 I think a better option might be a 350 Nismo or 370 Nismo s - Halo TTZ 18:08:19 09/27/12 370z/G37 spare wont clear my 13" StopTechs w.out a spacer (n/m) - Bernie (NoVA) 18:13:31 09/27/12 then he should keep a spacer w/ the spare? (n/m) - ForceFedTT (SoCal) 18:27:56 09/27/12 if already running a spare, one shouldn't be running hard - Halo TTZ 19:13:39 09/27/12 I need to test what size spacer is needed, have some to try (n/m) - Bernie (NoVA) 01:05:58 09/28/12 Toyota wheel center bore is smaller then 66.1mm will not fit (n/m) - Bernie (NoVA) 18:12:19 09/27/12 Re: Toyota wheel center bore is smaller then 66.1mm will not fit - MrPulldown(Tahoe) 18:57:50 09/27/12 Not to mention the tools you would need (n/m) - ZXoltan 20:59:26 09/27/12 the solution to that could be.. - Dane (Houston) 19:15:51 09/27/12 I would just have a machine shop bore out the center it - 5280Z_nightstalker 01:49:28 09/28/12
Post a Followup	You cannot reply to this message because you are not logged in.