Subject	rofl... cause it's true. (n/m)
Posted by	spicyZ on September 27, 2012 at 2:07 PM
	This message has been viewed 135 times.
In Reply To	My wife yelling, "When are you gonna stop working on posted by zellamay on September 27, 2012 at 01:21 PM
Message
Follow Ups	What Annoys the Hell Out of you Working on the Z? - ZXRider 12:40:40 09/27/12 Trying to fit under the pass side dash to remove the AC Evap (n/m) - whip 12:45:41 09/27/12 ... or the heater core. (n/m) - Shiers69 13:11:24 09/27/12 My wife yelling, "When are you gonna stop working on - zellamay 13:21:41 09/27/12 hahahaha 2nd - mikehawkhertz 13:49:18 09/27/12 rofl... cause it's true. (n/m) - spicyZ 14:07:34 09/27/12 they don't seem to understand the therapeutic value - aliaZ 06:53:29 09/28/12 Feeling like I just opened the hood and got my hands dirty.. - gizmo 13:34:09 09/27/12 ^^ big 2nd ^^ (n/m) - white22sky 16:29:57 09/27/12 working on the z. (n/m) - fuzzymonkey 13:44:03 09/27/12 Breaking brittle connectors. Otherwise, not too much. (n/m) - Z1 ZONLY 13:47:27 09/27/12 That I am working on it and not driving it. (n/m) - RaeCathode 14:01:14 09/27/12 Small garage. (n/m) - BoneZ (MD) 14:05:36 09/27/12 No garage - Krazyd27(Houston) 14:12:35 09/27/12 if you drive the car forward, you'll be in the garage (n/m) - fuzzymonkey 14:53:43 09/27/12 False. I would go straight into the house - Krazyd27(Houston) 15:01:36 09/27/12 AND THEN you'd have a garage :D (n/m) - fuzzymonkey 15:21:56 09/27/12 Haha and one hell of a house repair bill D: (n/m) - Krazyd27(Houston) 15:56:12 09/27/12 Please tell me you don't go under the car with only a jack - Aqualung 16:05:57 09/27/12 No sir, I was inspecting the tires before I went to the - Krazyd27(Houston) 16:44:31 09/27/12 Forgot to include pic in previous post - Krazyd27(Houston) 16:48:51 09/27/12 ^2nd. small garage = no big projects. (n/m) - 90TT Zfan (E.Tenn) 14:50:16 09/27/12 It can be done! I've built whole cars in a tiny 1 car garage - Jayru 14:58:06 09/27/12 Pussy, George did his swap in a garage with a foot on each - BigTDogg (MA) 12:52:30 09/28/12 Dropping anything. - TriniTT 14:14:15 09/27/12 checking fuses in driver footwell! - MidLifeZ (DFW) 14:30:34 09/27/12 God forbid, the relays BEHIND the fuse box - fuzzymonkey 14:55:31 09/27/12 Removing an SPL Radiator - ZinnZ32 14:58:03 09/27/12 Ugh, you just made me not look forward to installing mine - Jayru 15:00:31 09/27/12 Well, there were many swear words involved... - ZinnZ32 15:43:57 09/27/12 Ouch! Did your motor mount fail or something? - Jayru 16:04:40 09/27/12 No, it's just how it fit. Barley any clearance with piping - ZinnZ32 17:40:06 09/27/12 Will do. Thanks! (n/m) - Jayru 21:51:20 09/27/12 Jacques your car high enough, and install the rad from - fuzzymonkey 15:25:17 09/27/12 Ever tried to re-nylon the antenna mast? - Stokens (StoMoZTT) 15:35:43 09/27/12 Try to adjust the clutch pedal on a RHD Z (n/m) - ArubaDave 16:02:00 09/27/12 Why? It takes me hours to adjust a LHD Z :D (n/m) - MrOzzie5183 16:24:25 09/27/12 LHD Z tthe clutch is the closest to the door - BlackholeZ 16:58:33 09/27/12 Rear main seal and tranny stabbin'! Effin trannies :-( (n/m) - ConVerTT 17:57:39 09/27/12 2nd that, miserable b!tches (n/m) - vorpalZ 21:36:27 09/27/12 Re: Rear main seal and tranny stabbin'! Effin trannies :-( - gt300zxtt(HI) 03:28:45 09/28/12 That is a good idea (n/m) - ConVerTT 10:19:49 09/28/12 I also use studs for tranny stabbing - aliaZ 18:40:38 09/28/12 Getting a new alty belt just right - no squeeling.... (n/m) - jzack 18:13:42 09/27/12 is that what is causing the perpetual low squeal?? - LJZTT 06:48:43 09/28/12 T-Top mouldings, slicktop mouldings, when youve had your - Dane (Houston) 20:13:55 09/27/12 The clips that hold the trim piece just over the stereo - Spectrum (WI) 22:25:13 09/27/12 Having to drive all the way back to Omaha for a place to - Piranha 23:09:03 09/27/12 Denver is closer :) (n/m) - Woody75 (Denver) 11:28:30 09/28/12 Efi harness cover in the cabin tucked behind the evap - gt300zxtt(HI) 03:39:09 09/28/12 ...finding someone that can actually work on the car (n/m) - SuparexTT 11:16:27 09/28/12
Post a Followup	You cannot reply to this message because you are not logged in.