TwinTurbo.NET: Nissan 300ZX forum - i am just going to say something here: IPP built engines
People Seeking Info
 
   


     
Subject i am just going to say something here: IPP built engines
     
Posted by genic on September 20, 2012 at 2:59 PM
  This message has been viewed 657 times.
     
     
Message are rock f-ing solid.


ANYONE thinking of getting a short or long block...i HIGHLY recommend them. HIGHLY!

specs on mine (someone else ordered it, but it came from woody)
wiseco 88mm pistons
eagle rods
ceramic coating
machine work block - oil passages cleaned, block redecked, block bored and honed with torque plate, crank balanced and welded on center weight, and new rod/main bearings which are ceramic coated as well.
machine work heads - heads pressure teasted, oil passages cleaned, heads redecked, ported exhaust and intake runners, 9872865234 angle valve job (suck on that angle ash!), valve heights set, oem valve steam seals
all the typical 60k stuff
hydraulic lifters with JWT HD valve springs (which do kinda tick..but not way loud..and i may put in some different cams later due to the heads being setup for them already)
all ARP stud's including the main studs in the block

...again..nothing wild...but rock fucking solid. IPP (and kyle) build a great engine. HIGHLY recommend anyone who feels a little leary aboot putting their own engine together...and you want some tender loving care put into the engine while its being built...look no futher than IPP!

oh yea...make sure you check your rev limiter is set at a reasonable level. ..my PSA for the day :)


     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.