Subject	Camshaft removal from a '95 TT in LKQ salvage?
Posted by	SMAZ (OKC) on September 10, 2012 at 10:44 PM
	This message has been viewed 1249 times.
Message	I've got a chance to pull some cams or heads out of at 95 TT manual in a local LKQ salvage. Is there anything special I need to worry about when pulling them? I planned on just pulling the sprockets off, then sliding the cams out. If I could get the heads I would, but not sure I can reach all the bolts since the motor is still in the car. I'll be grabbing the solenoids too. Planning on using these to add VTC to my '96. Just happen to be returning tools at an autozone where a guy works and he mentioned he grabbed lots of stuff from a complete '95TT black 5 speed (suspension, JWT ECU, plenum etc.) Finally found me replacement door panels with no elbow crack in them!!!!! Pulled both, so I'll have the passenger side available if someone needs it. Also pulled several interior bits and plan to pull the steering wheel. Brought home a nice 3rd brake light too. If someone needs the spoiler, I could probably get it. Going back in the morning to pull the UD crank pulley as well. The rear brake pads may get pulled as well, they're blue so anyone know what these might be? If someone needs something let me know and I'll check. The LKQ just opened up 3 weeks ago. 1996 TT #61 of 300
Follow Ups	Camshaft removal from a '95 TT in LKQ salvage? - SMAZ (OKC) 22:44:46 09/10/12 Cams don't just "slide out" - BlackholeZ 22:49:37 09/10/12 Can I simply unbolt the jacket covers and pull them up? - SMAZ (OKC) 23:42:12 09/10/12 yeah, that works - BlackholeZ 02:33:50 09/11/12 Pull those 48P heads :) (n/m) - samsung-Z [Houston] 00:22:57 09/11/12 How difficult with the engine in the car? (n/m) - SMAZ (OKC) 00:58:09 09/11/12 Could be a PITA - BlackholeZ 02:36:53 09/11/12 Thanks, I read about those. I'll take the saw :) (n/m) - SMAZ (OKC) 07:36:14 09/11/12 Pull the lower plenum with it. The lower plenum is - MixManMash 08:19:21 09/11/12 Sawzall thru the cast iron mani's?? - ZXoltan 08:19:26 09/11/12 Put on the "make it go away" blade and bring a can of WD40 - BlackholeZ 19:48:24 09/11/12 Blue rear pads are stock Nissan pads (n/m) - Bernie (NoVA) 00:28:16 09/11/12 How do I remove the UD pulley without damaging it? - SMAZ (OKC) 01:23:23 09/11/12 Puller big enough to reach the thickest part of the pulley (n/m) - Bernie (NoVA) 08:33:25 09/11/12 warm it up with a torch and it will slip right off - aliaZ 12:08:26 09/11/12 Thanks guys. Got it off no problem, as well as cams and - SMAZ (OKC) 18:23:17 09/11/12
Post a Followup	You cannot reply to this message because you are not logged in.