Subject	They should not have coated the top lip where the oil cap
Posted by	whip on August 30, 2012 at 8:56 PM
	This message has been viewed 154 times.
In Reply To	So, I messed up painting my own valve covers over the posted by SpeedyZX on August 30, 2012 at 05:07 PM
Message	screws in. My guy tapes them off and polishes it back to stock as with other parts that require a factory seal. I have just never seen a decent PC shop do that before. That being said, the finish looks good. And $200 seems high, it's not much extra work/time to remove the mess.
Follow Ups	So, I messed up painting my own valve covers over the - SpeedyZX 17:07:38 08/30/12 It would have cost you $10 for aircraft paint stripper - TriniTT 17:24:02 08/30/12 The $200 is inclusive of other prep-work and powdercoating. - MixManMash 17:29:14 08/30/12 I was thinking, - TriniTT 17:48:19 08/30/12 I actually really, really wanted to get the wrinkle finish. - SpeedyZX 18:06:51 08/30/12 Unfortunately, I was under a time crunch for ZCON and had - SpeedyZX 17:33:29 08/30/12 True. - TriniTT 17:43:56 08/30/12 aircraft paint stipper works great. But since you had no - bjZ 19:11:31 08/30/12 No sand blasting, soda blasting is ALOT safer (n/m) - toykoz32 20:06:19 08/30/12 Agree, sand blasting requires a LOT of careful clean-up (n/m) - cherryz 10:50:00 08/31/12 It's a shame that you can hardly see them once installed. (n/m) - SWhiteTT(WA) 19:47:04 08/30/12 They should not have coated the top lip where the oil cap - whip 20:56:04 08/30/12 Sorry but they took you to the cleaners, first they did not - CmyZ 00:21:56 08/31/12 gotta say he's right - BlackholeZ 00:42:23 08/31/12
Post a Followup	You cannot reply to this message because you are not logged in.