Subject	Nicely done..
Posted by	Drk93TT on August 29, 2012 at 9:59 PM
	This message has been viewed 130 times.
In Reply To	First Plenum Install... posted by Lumpydonut on August 29, 2012 at 08:26 PM
Message	I always just razorblade and make sure the surfaces are perfectly smooth and bare metal.. then OEM paper gasket, no sealants needed. If you want you could use a little bit of the 3M yellow gasket sealant.. my dad loves that stuff and uses it religiously when he rebuilds old kawasaki's and hondas. Definitely not required though for this application. src="http://i47.photobucket.com/albums/f192/drk93tt/Picture6.p ng">
Follow Ups	First Plenum Install... - Lumpydonut 20:26:13 08/29/12 I replace the gasket with a brand new OEM one EVERY pull - MrOzzie5183 20:41:19 08/29/12 Good job, I never use any sealant. Clean the gasket - CmyZ 21:10:41 08/29/12 Looking at the FSM it only shows like 15ft/lbs on the bolts. - Lumpydonut 08:48:59 08/30/12 Yes that is the torque specification. That is what I use. - CmyZ 09:21:09 08/30/12 15 is so dinky! My torque wrench won't work that low :( (n/m) - fuzzymonkey 11:24:53 08/30/12 I bought an inch pound torque wrench - MrOzzie5183 12:49:00 08/30/12 Nicely done.. - Drk93TT 21:59:25 08/29/12 I used a razor to get a majority of the gasket off - Lumpydonut 11:21:07 08/30/12
Post a Followup	You cannot reply to this message because you are not logged in.