Subject	Good job, I never use any sealant. Clean the gasket
Posted by	CmyZ on August 29, 2012 at 9:10 PM
	This message has been viewed 140 times.
In Reply To	First Plenum Install... posted by Lumpydonut on August 29, 2012 at 08:26 PM
Message	surface areas properly and install a new OEM gasket. Torque it in multiple steps and sequence, to achieve the rated torque specification. That's all I do..I hate specially when I see the orangey gasket maker on any Z.
Follow Ups	First Plenum Install... - Lumpydonut 20:26:13 08/29/12 I replace the gasket with a brand new OEM one EVERY pull - MrOzzie5183 20:41:19 08/29/12 Good job, I never use any sealant. Clean the gasket - CmyZ 21:10:41 08/29/12 Looking at the FSM it only shows like 15ft/lbs on the bolts. - Lumpydonut 08:48:59 08/30/12 Yes that is the torque specification. That is what I use. - CmyZ 09:21:09 08/30/12 15 is so dinky! My torque wrench won't work that low :( (n/m) - fuzzymonkey 11:24:53 08/30/12 I bought an inch pound torque wrench - MrOzzie5183 12:49:00 08/30/12 Nicely done.. - Drk93TT 21:59:25 08/29/12 I used a razor to get a majority of the gasket off - Lumpydonut 11:21:07 08/30/12
Post a Followup	You cannot reply to this message because you are not logged in.