Subject	First Plenum Install...
Posted by	Lumpydonut on August 29, 2012 at 8:26 PM
	This message has been viewed 481 times.
Message	I have read and read that the plenum pull/install was easier after deletes but wow! When I pulled it a while back took me and a buddy over an hour to finesse that turd off. Put it back on today and it took me alone maybe 15 minutes to get it bolted down and everything in place to be connected. Only question I have is, are you supposed to use Permatex on the gasket? Before... After!
Follow Ups	First Plenum Install... - Lumpydonut 20:26:13 08/29/12 I replace the gasket with a brand new OEM one EVERY pull - MrOzzie5183 20:41:19 08/29/12 Good job, I never use any sealant. Clean the gasket - CmyZ 21:10:41 08/29/12 Looking at the FSM it only shows like 15ft/lbs on the bolts. - Lumpydonut 08:48:59 08/30/12 Yes that is the torque specification. That is what I use. - CmyZ 09:21:09 08/30/12 15 is so dinky! My torque wrench won't work that low :( (n/m) - fuzzymonkey 11:24:53 08/30/12 I bought an inch pound torque wrench - MrOzzie5183 12:49:00 08/30/12 Nicely done.. - Drk93TT 21:59:25 08/29/12 I used a razor to get a majority of the gasket off - Lumpydonut 11:21:07 08/30/12
Post a Followup	You cannot reply to this message because you are not logged in.