Subject	My bad. I didn't realize you had 700BBs. I would just get
Posted by	MixManMash on August 12, 2012 at 12:48 AM
	This message has been viewed 79 times.
In Reply To	If I go with stickers do I have to swap stuff out? posted by Rogy on August 11, 2012 at 10:04 AM
Message	a new CHRA for it and use them. No sense in upgrading there. All you need to do in the future is add Ashspec intake and IC piping. FWIW, it may be worth it while the engine is out to do at least the intake piping. The IC piping could always be done after. Add in some BDE motor mounts for the intake piping.
Follow Ups	I got the worst news... a turbo is shot. Looking to customiz - Rogy 15:52:21 08/10/12 Why are you looking at a used engine for a blown turbo? - ConVerTT 15:59:50 08/10/12 Because I have low compression in one cylinder by 25 percent - Rogy 17:39:33 08/10/12 Personally? Grab that motor and replace the CHRA - ConVerTT 18:18:27 08/10/12 Agreed. As for upgrading the turbos, the stockers can do a - MixManMash 22:52:59 08/10/12 If I go with stickers do I have to swap stuff out? - Rogy 10:04:50 08/11/12 Yes...you'll need to swap your 5 bolt DPs for 4 Bolt DPs. - MikeD (Philly) 15:01:57 08/11/12 Why stockers? You can get a new CHRA for the 700s (n/m) - ConVerTT 00:03:31 08/12/12 My bad. I didn't realize you had 700BBs. I would just get - MixManMash 00:48:25 08/12/12 How much does it cost for new chra - Rogy 23:03:16 08/12/12 My 530s with my built motor, headwork, cams and IC piping is - MixManMash 11:51:25 08/13/12
Post a Followup	You cannot reply to this message because you are not logged in.