Subject	I've read both that you do and don't have to grind...
Posted by	Crim on August 11, 2012 at 9:03 PM
	This message has been viewed 117 times.
In Reply To	NA to TT TRANS SWAP posted by krstull93 on August 11, 2012 at 08:26 PM
Message	When I did my TT swap, I lightly ground out the inside of the bell housing near where the starter was, but that was it...not even sure it was required.. 1990 2+2 TwinTurbo
Follow Ups	NA to TT TRANS SWAP - krstull93 20:26:33 08/11/12 I've read both that you do and don't have to grind... - Crim 21:03:50 08/11/12 The grind around the starter is required. My RPS Segmented - PiotrC70 23:29:51 08/11/12 I highly recommend buying this instead of fooling with shims - Crim 09:55:57 08/12/12 Something wrong with 2 mm washers? Why do you - ConVerTT 10:54:01 08/12/12 I'll 2nd the RameyZ shim. Only reason not to use washers - PiotrC70 11:27:54 08/12/12 Fair enough (n/m) - ConVerTT 14:35:42 08/12/12 Agreed. Like this solution. (n/m) - Bernie (NoVA) 00:54:47 08/13/12
Post a Followup	You cannot reply to this message because you are not logged in.