Subject	GTX 2860R Dyno
Posted by	Greg D. (Specialty-Z) on August 07, 2012 at 2:33 PM
	This message has been viewed 9375 times.
Message	Had a chance to install and dyno a set of GTX2860R Turbos The engine was completely stock, the dyno chart on pump looks very similar to a normal GT28RS turbo with the same mods telling me that the stock heads and cams can not flow any more at the same pressure. The GTX turbos did shine on race fuel...... With stock heads and cams the GT28RS typically only make 620 to 630 RWHP, The GTX2860 ended up making 737 Rear Wheel HP through the stock heads and cams :-) The GTX2863 and GT2867 should produce some awesome results with heads and cams that can move more air! Here are the mods and Dyno. The car was a 1995 Z32 SMZ with 20K original miles. The engine is completely stock and parts were only bolted onto it. Ash intake pipe kit with JWT pops x2 Selin translator MSP manifolds GTX2860R turbos Ash 2.5" Charge pipe kit Ash 2.5" Massive Intercoolers Stock TB's SZ 3" expansion 5 bolt Downpipes SZ 3" to 2.5" testpipes SS SZ 2.5" Single Oval tip Catback W/Res X SS Blitz SBC ID Spec-R Boost controller BDE Motor Mounts SZ ECU map switcher Nismo 740cc injectors J&S Knock controller 94 Octane pump power 94 Octane pump Torque Q-16 Power
Follow Ups	GTX 2860R Dyno - Greg D. (Specialty-Z) 14:33:03 08/07/12 Awesome info! Thanks for sharing. (n/m) - SimaYi 14:38:20 08/07/12 So let me get this straight.. It put down 700+ w/stock block (n/m) - sdhsbaseball 14:47:02 08/07/12 Yes, that is nothing new, just needs to be clean PoWeR (n/m) - Greg D. (Specialty-Z) 14:53:52 08/07/12 When are you and Seb going to be in the South again? lol (n/m) - sdhsbaseball 15:26:11 08/07/12 +1 - I'll pitch in for their hotel rooms lol (n/m) - Stokens (StoMoZTT) 15:49:47 08/07/12 Tuning in TX in Oct, St. Louis in Nov........ - Greg D. (Specialty-Z) 17:56:52 08/07/12 delaware!! - AC[dover] 18:05:35 08/07/12 St. Louis is an 8 hour drive. Need to check into that Thanks (n/m) - sdhsbaseball 08:53:18 08/08/12 You guys need a tour bus, lol. (n/m) - BigTDogg (MA) 14:09:57 08/08/12 The stock block will hold the power just fine. - Machtavian 10:06:25 08/08/12 Dual fuel pumps? Or stock fuel pump? (n/m) - ZonaZ 14:59:04 08/07/12 Stock Pump 20K on car, pressure dropped on last 2 runs - Greg D. (Specialty-Z) 15:08:10 08/07/12 ... paging Mixman, your new turbos are ready ... (n/m) - vorpalZ 15:07:15 08/07/12 In a few more years.... Pretty sweet results. - MixManMash 23:50:06 08/07/12 94 Octane? Q16 is beastly (n/m) - BigTDogg (MA) 15:16:53 08/07/12 i know there are a lot of variables, but it doesn't seem - vulcanrush 15:31:54 08/07/12 How come VP113 isn't as popular. It's $8.50 vs Q16 @ $13.50 (n/m) - evan_aggie 16:00:22 08/07/12 110 and 113 were formulated for higher C/R NA engines - Greg D. (Specialty-Z) 18:00:17 08/07/12 94 octane pump? Would like to see some 91 octane #s (n/m) - Piranha 18:27:18 08/07/12 If you look at the chart, you will see I posted......... - Greg D. (Specialty-Z) 19:17:12 08/07/12 Me,too. (n/m) - ForceFedTT (SoCal) 20:34:42 08/07/12 Customer lives in Canada and wanted a 94 octane tune - Greg D. (Specialty-Z) 21:13:56 08/07/12 Ahh..I see. (n/m) - ForceFedTT (SoCal) 03:33:22 08/08/12 Ah, makes sense. I hadn't heard of 94 in the States since - BigTDogg (MA) 12:21:20 08/08/12 Yea that was what I was thinking also. (n/m) - Piranha 20:27:17 08/08/12 Very nice! (n/m) - Inzane 15:43:19 08/07/12 can you do an overlay of the GTX2860 on a GT2860? (n/m) - aliaZ 16:08:54 08/07/12 more charts......... - Greg D. (Specialty-Z) 17:26:41 08/07/12 wow...GTX with cams and portwork should be a monster - aliaZ 18:11:15 08/07/12 Time to tear my car apart yet again - lol (n/m) - ztunerz 19:49:35 08/07/12 at this rate I'll never get mine together (n/m) - aliaZ 09:36:25 08/08/12 wow, it's amost looking like there is no point getting the - live4strength 05:07:12 08/08/12 Impressive performance - RobZ32 10:39:19 08/08/12 Greg, could you compare GTX2860 and EXP-90, at least on - Dark Diver 17:20:39 08/08/12 Thats disapointing. - Antihero 16:56:13 08/07/12 And when is the FX50 version going to be available??? :) (n/m) - RAGTPZ 17:17:42 08/07/12 It's all about the flow! :) - samsung-Z [Houston] 17:23:19 08/07/12 Nice! (n/m) - John@Z1 17:51:54 08/07/12 I should just forgo rebuilding mine - XTZ 18:08:35 08/07/12 nice !! (n/m) - The Devils Z 20:31:31 08/07/12 Why stock TBs? (n/m) - ForceFedTT (SoCal) 20:39:20 08/07/12 Customer declined upgrading them (n/m) - Greg D. (Specialty-Z) 21:08:58 08/07/12 how significantly do you feel that impacted overall ###? (n/m) - Adam (NoVA) 23:16:41 08/07/12 I wonder how the GTX2863r will do (n/m) - ZiNnYc 07:37:15 08/08/12 Will the GTX3076's or 71's fit? - Fake_Blood 07:46:34 08/08/12 no. The GTX3071 and GTX3076 are not available in a T25 - aliaZ 09:35:50 08/08/12 This illustrates the direct impact that duping has had on - HighPsi (NorCal) 13:10:08 08/08/12 Aebler (sp?) made a T3 manifold, but never produced it - BigTDogg (MA) 14:09:17 08/08/12 Yup, thats the one, thanks. (n/m) - HighPsi (NorCal) 21:56:53 08/08/12 Re: no. The GTX3071 and GTX3076 are not available in a T25 - ouikikazz 13:47:40 08/08/12 what about the wastegate? - aliaZ 14:05:25 08/08/12 Re: what about the wastegate? - ouikikazz 15:18:39 08/08/12 .86 or .64? (n/m) - Cruicad 09:45:11 08/08/12 I'm going to guess .86 - Antihero 09:52:11 08/08/12 I'm going to say 0.64 ar. I'm pretty sure that's what was - MixManMash 10:54:52 08/08/12 they were .64 (n/m) - aliaZ 11:40:03 08/08/12 interesting. JWT says they have shipped test .86 units - Antihero 13:43:41 08/08/12 Nice job guys... - Machtavian 10:14:50 08/08/12 Wild! (n/m) - SeedyROM 11:16:38 08/08/12 Re: GTX 2860R Dyno - sky z 13:02:41 08/08/12 where were the turbos sourced? - blackomega 13:50:52 08/08/12 JWT (n/m) - aliaZ 14:02:37 08/08/12 Then I'm surprised they are not .86 - Antihero 14:41:52 08/08/12 Mike Smith confirmed they were .64 (n/m) - aliaZ 15:12:41 08/08/12 JWT said the same thing initially about .86 GT28RS. - MixManMash 15:59:01 08/08/12 yep (n/m) - aliaZ 21:18:37 08/08/12 gtx2860 - BLACK Z 21:26:04 08/11/12
Post a Followup	You cannot reply to this message because you are not logged in.