Subject	I have the one piece CZP on all my cars. You are right ...
Posted by	ConVerTT on July 27, 2012 at 5:27 PM
	This message has been viewed 188 times.
In Reply To	What are NA>TT guys doing for the hood prop support? posted by PiotrC70 on July 27, 2012 at 03:24 PM
Message	Drill the body and remove the rubber. Then bend the hood prop to reach the plastic clip .
Follow Ups	What are NA>TT guys doing for the hood prop support? - PiotrC70 15:24:45 07/27/12 You can fit the tab between the shroud & radiator. - Bernie (NoVA) 15:30:27 07/27/12 simple fix. Have the tabs cut off and rewelded in the TT - Red Hawk (CO) 15:43:18 07/27/12 My WinFactory kit has grown on me. It is a must now. =) (n/m) - evan_aggie 22:36:07 07/27/12 use your vice and bend that rod! - fuzzymonkey 16:13:21 07/27/12 This. Did the same thing, works great, Basically TT prop now (n/m) - ZinnZ32 17:38:09 07/27/12 I have the one piece CZP on all my cars. You are right ... - ConVerTT 17:27:54 07/27/12 Old pic but you get the idea - ConVerTT 17:36:39 07/27/12 I rarely post in the General forum... - MegaZ 20:30:04 07/27/12 Thanks, but I'm definitely looking at a 2pc design. I think - PiotrC70 23:32:03 07/27/12 wow.... motor is looking awesome Piotr!! (n/m) - rave 09:10:34 07/28/12 Thanks! One of these days, I'll make it down to Portland... - PiotrC70 10:26:41 07/28/12 trim the rails on the radiator and switch R to L brackets? (n/m) - LitlElvis 10:52:14 07/28/12 I got the the win factory strut (n/m) - BlackholeZ 11:41:49 07/28/12 Buy a bracket for the rad and the hood prop clip - John (MD) 10:07:07 07/29/12
Post a Followup	You cannot reply to this message because you are not logged in.